| Project "Leftie" - part #19 |
| |
|
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
|
| |
| (03.13.15) Things have picked up a bit over this week and I have crested the 300
hour mark, and I hate to say it, but there is a lot more to be done. The firewall I am chipping away at every
night for an hour here and 2 hours there, whenever I can sneak it in.
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
I have cut some more holes in the plate area, filled in some of the center
section and now have more steel to do the heater section. I have also cut out the battery support
brackets and will use them when I mount that up (with the heater) for spacing and figure out all the
interference points. It is coming along and I see the progress, but it is slow going. I hope to get
more accomplished this weekend.
cb (03.13.15)
|
| |
|
|
|
|
|
|
|
|
| |
(03.15.15) I am continuing along the path of the firewall and by the end of
yesterday, I was in a positition to start cutting holes and placing parts inside the firewall to make sure
they will fit and get all the supports in place for the battery tray... once all that is done, I will do
the finish welding and the attachment of the plate to the RHD steering side. I estimate another week or
so with this and we should be able to move onto the floor work and then hopefully some body work.
cb (03.15.15)
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
(03.18.15) I had a few more hours to get some firewall work done. It is
coming along. I was able to get most of the stuff in there and have it work and function as it should. A
lot more of what is needed is to clean up a lot of welding, weld on that plate, clean up the inside, and
cut a few more holes.
cb (03.18.15)
|
| |
| << Previous |
Next >> |
